LinuxCNC 2.10

Hi,
At first thanks a lot to the community for your effort to improve LinuxCNC.
I am using LinuxCNC 2.10 and it runs without problems on Debian Bookworm.
This morning pre0-5285 should be available. However on the buildbot only 4852 is downloadable and hasn't been updated since 2025-08-22.
Is there a new buildbot on which we get the newest version ? Or is it simply forgotten ?
Thanks again and have a nice day.
Philippe

Currently the master builds are failing:
buildbot2.highlab.com/buildbot/#/grid
And no debs are uploaded if the build fails.

I am not sure what the current problem is, possibly something in the docs.

You could try building from source, it's not particularly difficult.

Thanks for answer.
I built 2.10 successfully on a RP4 but I don't dare to try on the router.
I will wait for the next update.
PW