Base threadwith Mesa?

Phew, its taken a few years, but my irrecoverable account has finally been deleted and I have been able to re-register under my usual username,hoorah!

While trying to troublshoot a CNC router that has been running just fine for years and suddenly can't find its 5i25 card ... it occurred to me ... does a Mesa based install even need a base thread?  Surely just a servo thread is all thats needed?

Can I comment out the BASE_THREAD in [EMCMOT], remove the thread start in HAL and move any HAL things that were on the base thread to the servo thread?

I w

Check the hal file if there is anything using the base period, if not you can remove it.

Sorted, cheers.