pin locations

Just trying to hook up the spindle.
And don’t know what im doing. Lol
I can wire a overhead crane but this keeps me scratching my head

All the spindle control stuff would be on TB3

(the SSR outputs for FOR and REV and PWM for the speed control)

ok im starting to understand
but not the speed control PWM?

Sorry, I was wrong:

The SSRs (that you would use for spindle FOR/REV) are on TB3,
but the PWM controlled analog output is on TB2

so would the spindle enable be the variable voltage

Not sure what you mean here

At the physical interface level there is no enable, but rather FWD and REV

 

The 0-10 volt to control the speed

natas01 wrote:

so would the spindle enable be the variable voltage

No, spindle enable is just enabling the VFD, speed is controlled by variable voltage.

Theres no vfd there’s a image of what im trying to hook up in a earlier post
im trying to find out how to get variable voltage 

To get the variable voltage, you set up the TB2 PWM output for spindle use in pncconf
The 7I96S manual shows the TB2 pinout of the analog output

7I96S Spindle + goes to a 10 or 12V supply (on a VFD this comes from the VFD itself)
7I96S Spindle out is the 0--10V analog voltage that goes to the Drives VIN
7I96S Spindle- goes to the drives COM pin and the negative pin of the 10 or 12V supply