Headless

Hello Forum,
I have been wrestling with getting linuxcnc to run on a flask app on localhost for now. I can never seem to get the machine out of estop, power on, home and jog. I also tried using halcmd to do this. Same thing was happening. Is it even possible to do this? 
I have 2 boards, Mesa 7i95T and 7i96S. I have Linuxcnc 2.10~pre on an I5 computer and have also run  2.9 ISO on a stick to do this.
Thank you for your support,
Keith

Keith3D wrote:

Hello Forum,
I have been wrestling with getting linuxcnc to run on a flask app on localhost for now.

What does that mean?
For setting the network:
forum.linuxcnc.org/27-driver-boards/3559...ethernet-mesa-boards

Hi Keith,
I had the same or similar problem yesterday, when I tested my new 7i96s. The estop remained activatet. The cause was: I had configured one input as estop, but left it unconnected during the test.

I am using direct UDP to the board instead. Thanks for the input!