LCNC and Stepspeed?

Hello,
When using a parallel port, entering the jitter value in Stepconf results in the calculation of the maximum step rate. Does this figure—for example, 33333 Hz—apply to each axis individually, or to all axes combined?
Best regards,
Hans

Holzwurm56 wrote:

Hello,
When using a parallel port, entering the jitter value in Stepconf results in the calculation of the maximum step rate. Does this figure—for example, 33333 Hz—apply to each axis individually, or to all axes combined?

For each pin, parallel port so all pins can be controlled in parallel or at the same time.

Many thanks for your response.