You must select 'up/down mode' in the pintype combo box to have pncconf use output type 2. Did you do that?
I did not see it first. Now I found the option, thank you!
You say axis 0 do you mean X axis ? what happens with the other axis?
Yes, I mean X axis, which I assigned to PWM 0.
For other axes analog output remains 0 and enable outputs won't work.
It's probably because 7i48 has one common enable instead of per axis.
I guess that only hm2_7i43.0.pwmgen.00.enable works but others don't.
Of course when I start the machine hm2_7i43.0.pwmgen.00.enable actually enables all outputs and that's ok.
But in Pncconf only one axis can be tested.
You typed 'SVST_6_6' is that a typo on your part? The name is 'SVST6_6'
Yes I mistyped here.
I can't repeat this error. the config used the proper name. Something else must have gone on.
I just created another new config with SVST6_6, saved it, shut down pncconf, started it again and TPEN4_5 shows too.
But when I create a new config with another firmware SVST6_6_7I48 that I added to pncconf, it saves all parameters. So it's maybe just something odd.
