Mesa 5i25 step by step configuration

More
10 years 10 months ago #67294 by Ozcnc
Replied by Ozcnc on topic Mesa 5i25 step by step configuration
I'll give it a go.

I'll let you know in a 12 hours.

Oz

Please Log in to join the conversation.

More
10 years 10 months ago #67314 by Ozcnc
Replied by Ozcnc on topic Mesa 5i25 step by step configuration
Nope no luck.

:(

Please Log in to join the conversation.

More
10 years 10 months ago #67317 by PCW
Replied by PCW on topic Mesa 5i25 step by step configuration
Its going to be very difficult to help unless you explain what you did and what didn't work

Please Log in to join the conversation.

More
10 years 10 months ago #67318 by Ozcnc
Replied by Ozcnc on topic Mesa 5i25 step by step configuration
I did this:
sudo mesaflash --device 5i25 --write 5i25_dmmbob1x2.bit
sudo mesaflash --device 5i25 --reload
sudo mesaflash --device 5i25 --readhmid

This was not needed.
sudo apt-get install mesaflash

PnCConf I used this
probrfx2.

No movement .

I have no idea what I've missed.

Oz

Please Log in to join the conversation.

More
10 years 10 months ago #67319 by PCW
Replied by PCW on topic Mesa 5i25 step by step configuration
How are the drives enabled? This is very likely not handled yet

Please Log in to join the conversation.

More
10 years 10 months ago #67320 by Ozcnc
Replied by Ozcnc on topic Mesa 5i25 step by step configuration
I have added the file.

Oz

Please Log in to join the conversation.

More
10 years 10 months ago #67321 by PCW
Replied by PCW on topic Mesa 5i25 step by step configuration
The enable question is more of a hardware/wiring question,
that is what type of drives do you have and what BOB signal
enables the drives?

Please Log in to join the conversation.

More
10 years 10 months ago #67322 by Ozcnc
Replied by Ozcnc on topic Mesa 5i25 step by step configuration
Now that is a good question.

Excuse my blondness what is BOB Signal?

As far as I can remember its benezan electronics beast 5.

That's as far as I got with the original manufacturer of the controller and drives.

Please Log in to join the conversation.

More
10 years 10 months ago #67323 by Ozcnc
Replied by Ozcnc on topic Mesa 5i25 step by step configuration
Oh bread out board.

beast 5.

or Zero 3 from cnc-step.

Please Log in to join the conversation.

More
10 years 10 months ago #67325 by emcPT
Replied by emcPT on topic Mesa 5i25 step by step configuration
Have a look here:

www.wiki.eusurplus.com/index.php?title=Category:Mesa_Interface

We have a good tutorial with pictures to use with a 5i25 + 7i77

Please Log in to join the conversation.

Time to create page: 0.058 seconds
Powered by Kunena Forum