Velocity Won't Exceed 6000mm

I'm trying to test my stepper drivers in PncConf, but the test window won't allow me to adjust the velocity beyond 6000mm/s.

I don't know what is happening. Please help.

THEQYD wrote: I'm trying to test my stepper drivers in PncConf, but the test window won't allow me to adjust the velocity beyond 6000mm/s.

I don't know what is happening. Please help.

360m/min how fast do you want it to go

THEQYD wrote: I'm trying to test my stepper drivers in PncConf, but the test window won't allow me to adjust the velocity beyond 6000mm/s.

That is 21kph or 13mph. What are you building?

Apologies, the measurements were minutes, not seconds.

If you need higher speeds than the Wizards allow (though I am not sure why the wizards would enforce limits) then you can hand-editt he maximum velocities in the INI file:

linuxcnc.org/docs/2.7/html/config/ini-config.html