Newbee Lost on setting !

Dell D620 with Docking Station for Parallel port . LinuxCNC2.5
Is this right ? Pncconf is to set up the parallel port in LinCNC and Mesa is type or hardware/software used for parallel port,In my case Dell Docking station and daughter board is the Controller board in my case 5 axis bl-mach-v1.1 (china one I will only be using 3axiz )

I have I/O control port board set for 5i20 but lost on Firmware pick also ?

If you have a parallel port based system. you should use stepconf, not pncconf
pncconf is for Mesa hardware.

Thank You - Wow I must need a new Light Bulb I over look that one .