Time to setup my lathe with 7i76e

More
8 years 10 months ago #103662 by tecno
Replied by tecno on topic Time to setup my lathe with 7i76e - Need help!
All axes missing with motion code

Please Log in to join the conversation.

More
8 years 10 months ago #103663 by andypugh
Replied by andypugh on topic Time to setup my lathe with 7i76e - Need help!
Well, you will need a complete G76 command.

Please Log in to join the conversation.

More
8 years 10 months ago #103664 by tecno
Replied by tecno on topic Time to setup my lathe with 7i76e - Need help!
Have tried lathe-g76.ngc but it stops joint 0 exceeds positive limit

Please Log in to join the conversation.

More
8 years 10 months ago #103665 by tecno
Replied by tecno on topic Time to setup my lathe with 7i76e - Need help!
Managed to set touch off but now it stands still on g76 line

Please Log in to join the conversation.

More
8 years 10 months ago #103666 by andypugh
Replied by andypugh on topic Time to setup my lathe with 7i76e - Need help!
Is index-enable true or false?
Is motion.spindle-revs increasing by 1 per rev?
Is motion.spindle-at-speed true?

Please Log in to join the conversation.

More
8 years 10 months ago #103667 by tecno
Replied by tecno on topic Time to setup my lathe with 7i76e - Need help!
Motion. Spindle-revs is counting

Please Log in to join the conversation.

More
8 years 10 months ago #103668 by tecno
Replied by tecno on topic Time to setup my lathe with 7i76e - Need help!
Yes
Counting
False

Please Log in to join the conversation.

More
8 years 10 months ago #103669 by andypugh
Replied by andypugh on topic Time to setup my lathe with 7i76e - Need help!
Is spindle-revs counting _up_

Did any axes move when the G76 command was issued?

Please Log in to join the conversation.

More
8 years 10 months ago #103671 by tecno
Replied by tecno on topic Time to setup my lathe with 7i76e - Need help!
-177.0000 and counting up

No axes move

Please Log in to join the conversation.

More
8 years 10 months ago #103673 by andypugh
Replied by andypugh on topic Time to setup my lathe with 7i76e - Need help!
Can you try just a G76 command in MDI (cutting air).
It is entirely possible that the sample G-code hasn't even got to the G76 line.

Please Log in to join the conversation.

Time to create page: 0.096 seconds
Powered by Kunena Forum