7i76e error

you can do this in your Network config file
/etc/network/interfaces

hardware-irq-coalesce-rx-usecs 0

bbsr_5a wrote: you can do this in your Network config file
/etc/network/interfaces

hardware-irq-coalesce-rx-usecs 0

Not IRQ, !
Eth.
PCW mentioned it several times, ETH.
Just do a search for it.

If you want to understand more:

01.org/linux-interrupt-moderation

sudo ethtool -C eth0 rx-usecs 0
Replace eth0 with whatever the name of the ethernet card is.
forum.linuxcnc.org/27-driver-boards/3559...ethernet-mesa-boards

Hi tommylight,

the reason i found this old thread (and poorly not your sticky) was only the "DoIt not cleared" error message.
Maybe you could add this info, because if you search because you already have set things up and then get this error message, its harder to find it.

Cheers
Conny

Will add that promptly, as i can see why it would not find it.
Thank you.

Im confused. In the writeup for "hm2_eth ", he has this :
hardware-irq-coalesce-rx-usecs 0 ??

That's correct

putting

hardware-irq-coalesce-rx-usecs 0

in your interfaces file

is the equivalent of running:

sudo ethtool -C [your_ethernet_device] rx-usecs 0

but is done whenever the link comes up so automatic

github.com/dankamongmen/sprezzos-world/b...debian/README.Debian