Comments on settings

When I went to set up pnconf it set output scale to -10000. Maybe there was something I missed but I have gone through many times and can't find an input where I might have manually made it do it. Maybe it's something I did but if it's a bug I thought I would mention it.
It would also be really nice if the max RPM in the wizard was increased. For example a lot of spindles go to 24k.

The wizards are for a Basic Setup
You might go to all the stuff afterwards and set it to your Needs

Standard servo Mashines are only at 8k RPM

Can you post your pncconf file so I can diagnosis the problem?

Yes I can raise the spindle max rpm

What version of linuxcnc are you using?

Chris M