2 Motors on Y , linuxcnc 2.9 not moving together

Well Well , thanks again !
on off on on
makes 4 x steps not 8 x Shame on me :blush:
www.omc-stepperonline.com/download/DM556T.pdf

I have to try tomorrow ,

Also had this wrong xmax should be left and Xmin on the right side I used tool max min.


Thank you for PNCCONF!!!

Glad it was helpful.
Maybe we should add a router/plasma diagram too

Chris

YES it did...I understood it like

thx Chris, I had a hardware miscalc as well.

when do you think the bug with producing double minus is fixed?
I had to configure 30 times today and each time deleting twice the - to much..

are you typing the - in the sequence edit box?

What I am getting at is pncconf assumes you want tandem motors to home together so automatically adds - to the homing sequence.
The edit box is there just so you can change the order of homing axis.

I didn't add any checks for user added minus signs as I didn't think you that possibility.

Bottom line for now - don't edit the homing sequence and it should be fine

Chris

yes...sorry...thought -1 -2 means sync...will check tomorrow ...it only moved one motor without the -

minus does mean sync in the INI - Pncconf adds it automatically

right my bad added the - ...now its only one, will check tomorrow if both at the same time..
still struggling with home...limit etc.

I tend to get along with difficult parts , but struggle with simple easy things

I pushed a fix for the negative sequence to pncconf.

Don't feel bad, linuxcnc is a steep learning curve in the beginning.
And homing is not easy to get right the first time through.

Chris