Homing X and Y can't jog after homing?

ok fix the x direction.
Then as for homing which way do you want it to travel searching for home?

ie, usually I think y would home with the the table moving towards you.

Ok so I have managed to get the homing all sorted out except after all 3 axis homes the x and y axis won't move when I try jogging them, the z axis jogs no problem. I'm wondering if it's not coming off of the limit switches far enough but I can't seem to find where to change that. If Infact that is the problem?

This looks like a repost of your first post. Did you mean to send it?

If you have shared HOME/LIMIT switches, you need to add a HOME-OFFSET in your ini file to move of the limit switch soit does not trigger a limit error as soon as homing completes.

He does - .001 that's why it moved the ,001 when he jogged.

Chris

cmorley wrote: He does - .001 that's why it moved the ,001 when he jogged.

Chris

Not seeing that in his config.

Sorry a better way to say this is that the soft limit and home position are .001 apart. so there should be no problem.
he hasn't complained about an error message so being on limit switch is not the problem.

Ok got it working now.
The problem was in axis configuration, I had the positive travel distance set to 10 and the negative travel distance set to 0
So I just had to reverse that and it now works.
Thanks for everyone's help.

Well that doesn't sound right at all.