[SOLVED] Mesa 7i80HD-16: startup errors

More
5 years 10 months ago #191715 by travis036
[SOLVED] Mesa 7i80HD-16: startup errors was created by travis036
just testing my 7i80HD-16, yet i get errors (attached: linuxcnc.report.txt) right from startup. if i remove (comment out) the offending line, it just finds another error... and so on.

Thanks in advance for any help :)

~Travis

Please Log in to join the conversation.

  • BeagleBrainz
  • New Member
  • New Member
More
5 years 10 months ago #191716 by BeagleBrainz
Replied by BeagleBrainz on topic Mesa 7i80HD-16: startup errors
Have you tried changing the prefix from hm2_7i80hd.0. to hm2_7i80.0. ?

As the pins seem to being reported with the prefix hm2_7i80.0 not hm2_7i80hd.0

Please Log in to join the conversation.

More
5 years 10 months ago #191717 by travis036
Replied by travis036 on topic Mesa 7i80HD-16: startup errors
i have not tried that (pretty new to Mesa cards). i will try it a bit later, when i get back out there, thanks!

~Travis

Please Log in to join the conversation.

More
5 years 10 months ago #191721 by kavindu1
Replied by kavindu1 on topic Mesa 7i80HD-16: startup errors
i also had a same err with startup on my 7i80 hd

Please Log in to join the conversation.

More
5 years 10 months ago #191728 by travis036
Replied by travis036 on topic Mesa 7i80HD-16: startup errors
changed all "hm2_7i80hd" to "hm2_7i80"

now a new set of errors (attached report). when i got an error from the stepgen associated with the charge_pump, i removed it to see if it would help, but then i got the same error for the stepgen 00. fortunately, i haven't connected this to my machine yet. ;)

~Travis

Please Log in to join the conversation.

More
5 years 10 months ago #191729 by PCW
Replied by PCW on topic Mesa 7i80HD-16: startup errors
It appears that the configuration you have loaded in the FPGA card has no
stepgens present

Please Log in to join the conversation.

More
5 years 10 months ago #191730 by travis036
Replied by travis036 on topic Mesa 7i80HD-16: startup errors
this is what i am using...

Attachment not found



~Travis

Please Log in to join the conversation.

More
5 years 10 months ago #191732 by PCW
Replied by PCW on topic Mesa 7i80HD-16: startup errors
Right but that does not mean you have the correct firmware installed in the 7I80

What does:

mesaflash --device 7i80hd --readhmid

report?

Please Log in to join the conversation.

More
5 years 10 months ago #191733 by travis036
Replied by travis036 on topic Mesa 7i80HD-16: startup errors
i think i assumed that the pncconf flashed the FPGA... how do i flash the FPGA card?

~Travis

Please Log in to join the conversation.

More
5 years 10 months ago #191735 by PCW
Replied by PCW on topic Mesa 7i80HD-16: startup errors
with mesaflash

Please Log in to join the conversation.

Time to create page: 0.066 seconds
Powered by Kunena Forum