Error en PnCConf

More
5 years 8 months ago #197657 by chuben
Error en PnCConf was created by chuben
Hello, when I try to execute PnCConf I fill everything up to the axes page and when I want to turn the page I get the error of the image that I attach.
What I can do?
Thank you

Please Log in to join the conversation.

More
5 years 8 months ago #197684 by cmorley
Replied by cmorley on topic Error en PnCConf
What language are you using on the system?

Please Log in to join the conversation.

More
5 years 8 months ago #197725 by chuben
Replied by chuben on topic Error en PnCConf
I installed it in Spanish and then changed it to English because the TB4-TB5-TB6 outputs did not appear.

Please Log in to join the conversation.

More
5 years 8 months ago #197734 by cmorley
Replied by cmorley on topic Error en PnCConf
how did you change the language please?

Please Log in to join the conversation.

More
5 years 8 months ago #197735 by chuben
Replied by chuben on topic Error en PnCConf

cmorley wrote: how did you change the language please?

This link shows how to change the language: miguelmenendez.pro/es/blog/cambiar-idiom...stema-basado-debian/

Please Log in to join the conversation.

More
5 years 8 months ago #197736 by cmorley
Replied by cmorley on topic Error en PnCConf
What locale did you use.
Please be as specific and detailed as possible.

Please Log in to join the conversation.

More
5 years 8 months ago #197985 by chuben
Replied by chuben on topic Error en PnCConf
I reinstalled linuxcnc again and the language was set to American English

Please Log in to join the conversation.

Time to create page: 0.091 seconds
Powered by Kunena Forum