Spindle - 7i76e

Clive S wrote: Has this ever run with the parameters before.

Have you check the number of poles some of these vfd's come with them set at 2 or 4 if I am not mistaken I think they should be set for 2 PD143

4 is set default of VDS. This parametr i did not changed :´-(


Taday i ant to start mill oak glued beams, for this machine .... and nothing....

Can someone post setup VDF for :

2,2 kW HY inverter and 2,2 kW watter spindle:

Then Configure the VFD
PD001 = 1 (external terminal)
PD002 = 3 (which was not in manual)
PD044 = 1 (for RUN)
PD045 = 5 (DIR.......FOR /REW)

other PD* ?

I don´t want to burn next spindle..

Thank you very much

I would look a PD11 (min frequency)

Check PD141 to PD146, especially PD142 and PD146

You may need to pay attention to the V/F curve, PD04-PD10.