Error on "Test / Tune Axis

charleyann
Topic Author
Offline
Junior Member

5 years 6 months ago #204971 by charleyann

Error on "Test / Tune Axis was created by charleyann

In the Pnc Config Wizard I am getting this error when I select "Test / Tune Axis"

Attachment not found

If I comment out the print statements at line 689 the test runs. I don't know enough about python to fix it the right way.
Can anyone help?

Please Log in to join the conversation.

cmorley
Offline
Platinum Member

5 years 6 months ago #204972 by cmorley

Replied by cmorley on topic Error on "Test / Tune Axis

your quotes didn't come through.
What version of linuxcnc are you using?

Please Log in to join the conversation.

charleyann
Topic Author
Offline
Junior Member

5 years 6 months ago #204973 by charleyann

Replied by charleyann on topic Error on "Test / Tune Axis

I'm running 2.8.1
I fixed the attachment, you should see it now.

Please Log in to join the conversation.

cmorley
Offline
Platinum Member

5 years 6 months ago #204979 by cmorley

Replied by cmorley on topic Error on "Test / Tune Axis

change it to this:
if that works I'll push the fix

Code:

            for i in stepinvertlist[0]:
                   halrun.write("setp   " + self.step_signalname + ".step.invert_output   true")
            for i in stepinvertlist[1]:
                   halrun.write("setp   " + self.step_signalname + ".direction.invert_output   true")
            halrun.write("setp %s.step_type 0 \n"% (self.step_signalname))

Please Log in to join the conversation.

charleyann
Topic Author
Offline
Junior Member

5 years 6 months ago #205100 by charleyann

Replied by charleyann on topic Error on "Test / Tune Axis

That took care of it.
Thank You

I'm off to my stepper tuning adventure!

Please Log in to join the conversation.

Time to create page: 1.552 seconds