Re:pncconf - feature requests

Here is the dmesg output from earlier this morning. Using this line to load the driver

loadrt hostmot2 debug_idrom=1 debug_module_descriptors=1 debug_pin_descriptors=1 debug_modules=1




John

I dont think its anything low level just that the name in hal is wrong somehow. (the extraneous "/hm2")

The proper parameter name is in the parameter list (from your 5i25_7i77_pins_parameters.txt)

9 u32 RW 0x3B9ACA00 hm2_5i25.0.watchdog.timeout_ns

not sure if its a typo but Johns quote has 5125 instead of 5i25.

Sure looks like the name in the hal setp line is wrong, whatever the cause...

Chris,

Good catch on my typo and the two keys are not even on the same hand!

John

I do it too. 5125 is just more natural

Thank you for the 7i77 pinouts guys.
I assume this is mode 0 . is that the only mode?

Yes, it was mode 0, I don't know if others are supported yet... let me see if it blows up.

I'm not sure how to change the mode at this time. I changed the sserial part from 002XXX to 102XXX and it loaded but the pins seem to be the same.

John

mode 1 should add 4 analog inputs
mode 2 should add the 4 analog inputs plus field voltage
mode 3 should throw an error (well it may just cause all field I/O pins to disappear)

this is the first number in the config string
the second is for the analog out section (mode 0 only)
the third is for the expansion connector (not used unless you have an additional SSERIAL card)

BigJohnT wrote:

Chris,

Here you go... I had a bit of a time getting it up and running, didn't seem to like the setp hm2_5125.0.watchdog.timeout_ns 10000000 line.

Attachment 5i25_7i77_pins_parameters.txt not found

John

Chris,

This list is not complete as I didn't have the field power connected when I made it. I'll get you an updated list if you don't all ready have it...

John