Hello guys,
i configure 2 y axis on linuxcnc but i cannot move both at same time. I need help to edit .ini file manually to work.
many thanks
attached my config files
Attachment not found
You don't have any homing information in the ini and possibly none in the hal file.
It might be easier to re run PNCconf again and put the homing stuff in and then edit it.
This is an extract from mine:-
# final home position machine-unit/sec
HOME = 0
# use this to square the gantry
HOME_OFFSET = 2.5
# machine-units per sec next 2 lines
HOME_SEARCH_VEL = 30 (this is used to set the search speed )
HOME_LATCH_VEL = -5 (this is used to set the latch speed to back off the switch)
HOME_FINAL_VEL = 0 (this is used to set the speed to the home position )
HOME_USE_INDEX = NO
HOME_IGNORE_LIMITS = YES
HOME_SEQUENCE = -2 (this has to be a -ve number ie. -1 or -2 etc.)
And has to be the same in both synchronised joints
