Probe for corner

I mentioned earlier about an edit to add the offset for the probe. Here it is. I added so,me comments where I think they belong. I'm a complete rookie at Linux, so if there are any suggestions about how I went about this I'd love to hear them. Thanks again for making this widget it's really great!
Hahn Rossman
www.alkifoundry.com

That looks good. Nice addition. I do not use tool length compensation with my R8 holders so the Z was not developed.
Glad to hear it is of use to you.
I do plan on cleaning up the original and making it easier to read.

Rick G

Thanks heaps for this code Rick and hr!

I've just spent the evening tweaking it and getting to behave a bit better for the Z probing (just run in simulation in a VM so far, very handy to be able to do that).

I've written a bit of a guide on my site: 7xcnc.com/software/probing/probe-corner-ngcgui/
The full code is on that page.

Glad to hear it was of some help to you.

Rick G