Gcode preview and remap

I tried make dirty fix:
 

It dont work. Probably I need modification for Python 3 from Python.
 

I would like ask you for help.

 

it says right there at the end of the error message. In python, indentation is part of the syntax. It needs to say

The preview interpreter doesn't know if you want a subroutine displayed or not.

Try using the #<_task> parameter in your subroutine so it is only executed when you are actually running the gcode program.

#<_task> - 1.0 if the executing interpreter instance is part of milltask, 0.0 otherwise. Sometimes it is necessary to treat this case specially to retain proper preview, for instance when testing the success of a probe (G38.n) by inspecting #5070, which will always fail in the preview interpreter (e.g. Axis).

rmu wrote:

it says right there at the end of the error message. In python, indentation is part of the syntax. It needs to say

Code:

if fn == None: fn = self.ilename if fn.split.... notice same indentation level, you have additional indentation on the line with "if fn.split...". rule of thumb, if the previous line is a complete statement (no open parenthesis, ...) and doesn't end with a colon (":") then next line must be on same level.

It no longer gives the error message, but it didn't solve the problem. Still showing path of ATC. Still, thanks for the help.

Aciera wrote:

The preview interpreter doesn't know if you want a subroutine displayed or not.

Try using the #<_task> parameter in your subroutine so it is only executed when you are actually running the gcode program.

#<_task> - 1.0 if the executing interpreter instance is part of milltask, 0.0 otherwise. Sometimes it is necessary to treat this case specially to retain proper preview, for instance when testing the success of a probe (G38.n) by inspecting #5070, which will always fail in the preview interpreter (e.g. Axis).

The same advice give me rene-dev.
github.com/LinuxCNC/linuxcnc/issues/2651...uecomment-1729335327
But I dont know how use #<_task>.
 

I tried this:
But #<_task> is only readonly parameter.
 

This is an example from 'sim/axis/geometry/xyzc.ngc':


 

I have absolutely no idea how this is going to help me. I don't understand why I have to check #<_task>. I need the ATC exchange to happen every time, not just depending on some parameter. I just need Preview to ignore it.

I tried this:
(PREVIEW,hide)
<G-code to be hidden>
(PREVIEW, show)
linuxcnc.org/docs/2.9/html/gui/gmoccapy.html#_preview_control

But it didn't help on physical machine.

I'm stupid today.

Try this:

need the ATC exchange to happen every time, not just depending on some parameter. I just need Preview to ignore it.

The point is this:
gcode is run in a separate interpreter for the preview and for this the parameter #<_task> is = 0.
If the code is executed 'on the hardware' (by clicking on the 'Run' button) then the parameter #<_task> = 1.

So you check that parameter #<_task> == 1 to make the code in the if-endif subroutine invisible for the preview but execute it when you actually click on the 'Run' button.