soubroutines update values from gui interface problem

In the old 2.6 Lcnc whe I have a value that need to being update from gui or external input, I put it on soubroutine and call it from my primary.ngc file. If during the execution the user press "make an other way" button on axis panel an if statement see these action and perform the soubroutine... example;

and my primary.ngc example:

in the 2.6 if user change toggle button state during gcode execution, if statement perform right .... but with 2.8 master if user change toggle button state when Lcnc is in stop mode all is good, if user change during execution if statement bring only the past value of togglebutton and NOt the new one .....

there are some way to do these things in old manner?

regards
giorgio

I suspect this problem is created by the read ahead done by the new trajectory planner introduced in 2.7.

The trajectory planner does have a setting to revert to the old system. In the ini file under the [TRAJ] section there should be a line
ARC_BLEND_ENABLE = 1
change the 1 to 0

Changing that setting should revert to the old 1 line look ahead system, see if that returns your old behavior.

If you want to retain the new trajectory planner, you are going to have to use a different method other than changing a parameter value, to effect your change. I would suggest using an M66 instead.

G-code access to HAL pins has _never_ worked reliably during code execution.

It is, as Todd said, much better to net the toggle to a G-code input in HAL and then use M66.

thanks to all but I know M66 ... but never used in these situation: the user can perform more than one choose ... so 6 togglebutton ... than it can select a different velocity of certain mouvement so 4 different type of gladevcp.speedcontrol widget for example .... if use M66 can #5399 parameter change every time the gcode read M66? example:

these is possible?
Last time that I try do these things the trajectory planner "not understand" the right #5399 value every time...... (3/4 year ago)

regards
Giorgio

That is exactly what I would expect to use. (If it doesn't work then something is wrong)