hello guys
I want to store some parameters in the ini and then use them in my subroutine.
I am doing something wrong!
I have entered the following in the ini:
[GCODE_MIRROW]
x = 2486.3
the subroutine is:
Code:
[code][code][code]o<tool_move> sub
o100 if [EXISTS[#<_ini[gcode_mirrow]x>]]
(debug, #<_ini[gcode_mirrow]x>;)
o100 else
(debug, not available)
o100 endif
o<tool_move> endsub
m2
[code]When I now call the program I get not "x=10" but "not available".
where is the problem?
I try this in an axis sim 2.8.2
[/code][/code][/code][/code]
