Proof reading please. "unknown control command in o word"

Sziggy_NC
Topic Author
Offline
Junior Member

1 year 8 months ago #322118 by Sziggy_NC

Proof reading please. "unknown control command in o word" was created by Sziggy_NC

Could someone help me find my error?
The program orients the spindle and calls an unknown control command in o word. I have attached the toolchange.ngc that is throwing the error.

Please Log in to join the conversation.

tommylight
Away
Administrator

1 year 8 months ago #322124 by tommylight

Replied by tommylight on topic Proof reading please. "unknown control command in o word"

Code:

O105 elseif [#<selected_tool> LT 22]
	M3 S300 ; need rpm to orient
	M64 P6 ; orient spindle
	M66 P6 L4 Q9 ; check spindle orient
	o053 if [#5399 LT 0]
	(abort, failed to orient spindle)
	o053 endif

Notice o053 in two instances above, so i am guessing they should be O upper case as the rest of them.

Please Log in to join the conversation.

MaHa
Offline
Platinum Member

1 year 8 months ago #322127 by MaHa

Replied by MaHa on topic Proof reading please. "unknown control command in o word"

Line 12, M61 T0 should be
M61 Q0

Please Log in to join the conversation.

Sziggy_NC
Topic Author
Offline
Junior Member

1 year 8 months ago #322135 by Sziggy_NC

Replied by Sziggy_NC on topic Proof reading please. "unknown control command in o word"

That is going to be it. I'll make the change and check in the morning.

Please Log in to join the conversation.

Sziggy_NC
Topic Author
Offline
Junior Member

1 year 8 months ago #322217 by Sziggy_NC

Replied by Sziggy_NC on topic Proof reading please. "unknown control command in o word"

That fixed it.

Now I need to add a section to match the pocket to the tool when putting away the tool.

Please Log in to join the conversation.

Time to create page: 0.090 seconds