Help - Can't see the forest for the trees!

When I try to execute the attached macro from MDI in GMOCCAPY or AXIS I get the error:

Bad character '<'

Can't find anything incorrect in the file which I have attached. I went so far as to comment out all of the lines and just tried to open a LOG file to see where the error might be, but the error occurs before the file is opened.

An extra pair of eyes would be most appreciated.

Kind Regards,

Well, something is not right, i can not see the attached file, but if i choose to quote your message, it shows up!
Fro your file (as i have no clue if this is the issue)
<#factor> = 1 (Adjust for metric)
Probably should be
#<factor> = 1 (Adjust for metric)

Don't know why file didn't come through, but I'm pasting it here:

o<auto-xy-zero> sub
<#factor> = 1 (Adjust for metric)
o100 if [#<_metric> EQ 1]
#<factor> = 25.4
o100 endif

#<X-move> = [#<_ini[LASER]laser-offset-x> * #<factor>]
#<Y-move> = [#<_ini[LASER]laser-offset-y> * #<factor>]
#<feedrate> = [20 * #<factor>]

; (Move table to program start)
G91 G0 X#<X-move> Y#<Y-move> F#<feedrate>
G10 L20 P0 X0 Y0 A0 ( Set X/Y DROs to zero )

o<auto-xy-zero> endsub

m2

Looks to me that all of the references are correctly formatted.

Regards,

Second line does not look correct, see my previous post.
You have a # in the wrong place behind a < , it should be in front of it.