NGCGUI not working after emc2 update

John,
Well that really BORKED Axis....which to me, seems to be a good sign as Axis is starting from the proper files/locations

Mike

Yes that verified that the correct files are being loaded...

Zip up your entire configuration directory and attach it and I'll run it here on my 2.5 machine and see what we get.

John

BigJohnT wrote:

Yes that verified that the correct files are being loaded...

Zip up your entire configuration directory and attach it and I'll run it here on my 2.5 machine and see what we get.

John

John,
I have not attached a file before, I hope this works out...let me know if it does not...

BTW...thanks much for all the time you have devoted to this...I certainly do appreciate your time and efforts...

Mike

That didn't work, file was too large...send just the pertinent part...

Are you really using all those files

John

John,
LOL....I am experimenting....mad scientist type stuff...I do have a use for the files you see there, which may change with time, but I do have some things in mind for future use...

Mike

So far I'm stumped...

John

This config works...



I'm still not sure why your config does not work yet ...

John

John,
Thanks looking the file over to see what might be helpful in making mine work...

I do have a question regarding something I have not seen used before related to ngcgui...what am I looking at in the following of your file?

SUBROUTINE_PATH = ncsubroutines:/home/john/emc2/subroutines

is the identifier ":ncsubroutines": some type of pointer, if so, to where?

I am going to remove the "./" from the tcl's and give that a whirl

Will let you know how it all works out....

Mike

LOL, I can't remember what that does... I'm sure it was something that Dewey told me to do. One thing I notice when running your config I get a classicladder warning that I can't figure out yet...

John

Crap, I finally found it you have it in the [FILTER] section not the [DISPLAY] section...

John