Hi
I'm working on a new GUI for linuxcnc and I'v put following code into python file :
Code:
self._c = linuxcnc.command()
self._s = linuxcnc.stat()
self._e = linuxcnc.error_channel()
self._s.poll()
print self._s.task_state
if self._s.task_state == linuxcnc.STATE_ESTOP:
self._c.state(linuxcnc.STATE_ESTOP_RESET)
self._c.wait_complete()
self._s.poll()
print self._s.task_state
else:
self._c.state(linuxcnc.STATE_ESTOP)
self._c.wait_complete()
self._s.poll()
print self._s.task_state
But it prints two '1' (as state) which means linuxcnc in STATE_ESTOP and it's state cannot be changed to STATE_ESTOP_RESET. So it shows
Code:
self._c.state(linuxcnc.STATE_ESTOP_RESET)
dose not work correctly.
Anyone can help me?
