Gscreen Support for KINSTYPE=BOTH?

More
8 years 9 months ago #104163 by dpersuhn
Gscreen Support for KINSTYPE=BOTH? was created by dpersuhn
Any plans to update gscreen so that it will support the BOTH kinstype in master for folks taking advantage of the new joints/axes configurations on gantry machines?

Please Log in to join the conversation.

More
8 years 9 months ago #104184 by cmorley
Replied by cmorley on topic Gscreen Support for KINSTYPE=BOTH?
I can look into that - do you have a sample config that works as a sim?
I don't know whats required to support those Kins

Chris M

Please Log in to join the conversation.

More
8 years 9 months ago #104201 by dpersuhn
Replied by dpersuhn on topic Gscreen Support for KINSTYPE=BOTH?
I don't at the moment, but I'll put one together.

Please Log in to join the conversation.

More
8 years 5 months ago #110413 by thang
Replied by thang on topic Gscreen Support for KINSTYPE=BOTH?
I dont know if you still need help about this section but when i remove these lines:
github.com/LinuxCNC/linuxcnc/blob/master...interface.py#L31-L32
Then rebuild linuxcnc, i can use KINETYPE=BOTH

Please Log in to join the conversation.

Time to create page: 0.084 seconds
Powered by Kunena Forum