You may be the only person trying to use tklinuxcnc with
a 2.8 or higher version.
You can try commenting out one line in tklinuxcnc.tcl as
described (-,+) by the following diff:
=======================================================
Code:
$ git diff -c
diff --git a/tcl/tklinuxcnc.tcl b/tcl/tklinuxcnc.tcl
index 8014d1e040..ecbc9df256 100755
--- a/tcl/tklinuxcnc.tcl
+++ b/tcl/tklinuxcnc.tcl
@@ -2203,7 +2203,7 @@ proc updateStatus {} {
if {$::jointworld == "joint" && $teleop_mode} {
set ::jointworld "world" ;# radiobutton var
} elseif {$::jointworld == "world" && !$teleop_mode} {
- set ::jointworld "joint"
+ # set ::jointworld "joint"
}
# format the numbers with 4 digits-dot-4 digits
=======================================================
There may be unwanted side-effects to this change.
If using a RIP build, edit the file at:
your_linuxcnc_dev_directory/tcl/tklinuxcnc.tcl
If using a deb install, you will need to use sudo to edit
the file located at:
/usr/lib/tcltk/linuxcnc/tklinuxcnc.tcl
