Lockfile still not removed

More
3 years 6 months ago #268544 by wl
Lockfile still not removed was created by wl
Hallo, wenn ich versuche LinuxCnc über den Launcher zu starten wird der Axis screen nicht angezeigt, das Programm läuft allerdings.
Code:
wl@wolfgang:~$ linuxcnc LINUXCNC - 2.8.4-1-gb7824717b Machine configuration directory is '/home/wl/linuxcnc/configs/sim.axis' Machine configuration file is 'axis.ini' LinuxCNC is still running.  Restart it? [Y/n] Y Cleaning up old LinuxCNC... Shutting down and cleaning up LinuxCNC... Waiting for other session to finish exiting...lockfile still not removed
Und dann passiert nichts mehr...

Wäre nett wenn mir wer dabei helfen könnte
[img






 

Please Log in to join the conversation.

More
3 years 6 months ago #268546 by tommylight
Replied by tommylight on topic Lockfile still not removed
Im terminal:
halrun -U
Muss die grosse U sein am ende.

Please Log in to join the conversation.

More
3 years 6 months ago #268547 by wl
Replied by wl on topic Lockfile still not removed
Da passiert leider gar nichts

Please Log in to join the conversation.

More
3 years 6 months ago #268552 by tommylight
Replied by tommylight on topic Lockfile still not removed
Die selbe nach reboot?

Please Log in to join the conversation.

More
3 years 6 months ago #268555 by wl
Replied by wl on topic Lockfile still not removed
Nach dem reboot kann ich den Befehl ausführen. Aber wenn ich dann wieder den launcher klicke erscheint wieder kein Axis Screen.

Please Log in to join the conversation.

More
3 years 6 months ago #268599 by wl
Replied by wl on topic Lockfile still not removed

Please Log in to join the conversation.

Time to create page: 0.098 seconds
Powered by Kunena Forum