7i96s Watchdog Ethernet

in the BIOS, at a minimum, Disable AMT

 

Did you mean this?
 
 

AMT is still enabled

I think you need to enter MEBx to disable AMT

I would do a web search in the steps needed for this
on your particular CPU.

Also, posting your hal/ini files might help, getting a watchdog bite without a
"error finishing read"  is a bit odd

 

Hi Tommylight,
I installed your iso
Without any changes I get these Results 
 

In a short test without Watchdog error 
 

Next step is define the grub Parameter. But there's no grub customizer 

Regards 
Erwin 
 

Please post you hal/ini files
something basic is wrong with them

here are my config files for the machine
Due to the problems I have disconnected the motors. As a test, I had one motor rotating freely on the controller - no difference. I now have an oscilloscope and can check the output of the motor signals if necessary. Currently, only the Ethernet cable and the power supply are connected to the Mesa 7i96s.

Created with PnConf Standard with minimal settings. No limit switches and no sensors. Settings for my JMC cl stepper (microsteps, 5mm/rev ...)

Maybe I have a fundamental error in the configuration? 

 

Yeah, there are several odd .tmax entries, not sure what they are about,
this is what I get with a simple pncconf/gmoccapy configuration:

Parameters:
Owner   Type  Dir                 Value  Name
    38  s32   RW                      0  hm2_7i96s.0.read-request.tmax
    38  s32   RW                 661312  hm2_7i96s.0.read.tmax
    38  s32   RW                  62668  hm2_7i96s.0.write.tmax
    31  s32   RW                   4296  motion-command-handler.tmax
    31  s32   RW                  43264  motion-controller.tmax
    41  s32   RW                   3464  pid.s.do-pid-calcs.tmax
    41  s32   RW                   3472  pid.x.do-pid-calcs.tmax
    41  s32   RW                   4984  pid.y.do-pid-calcs.tmax
    41  s32   RW                   2916  pid.z.do-pid-calcs.tmax
    32  s32   RW                 760744  servo-thread.tmax

Where the heck do "base.tmax" and "servo.tmax" come from?

Hallo PCW, 
ich habe noch einige andere Einstellungen versucht aber ohne Erfolg.
Eigentlich ist das Hobby fräsen und nicht Einstellungen in Linux CNC zu testen.
Deshalb habe ich überlegt einen Raspberry Pi 5 8gb zu kaufen. Jederzeit verfügbar, ein fertiges Image, kein raten / testen, passt bequem in den Schaltschrank. 

Hältst du das für sinnvoll?

Grüße Erwin 
 

It's worth a try, but...

Did you actually disable AMT?

Still don't know where base.tmax" and "servo.tmax" come from.
These are suspicious as they do not exist in a standard LinuxCNC installation.