Watchdog-Fehler beim Programmstart?

Hallo,
wenn ich Lcnc starte kommt irgendwann die Meldung:
"hm2/hm2_7i96.0: set the.has-bit pin to False to resume"
Was könnte man da Machen? Ich benutze Axis und die Mesa 7I96, Maschinenart = Drehmaschine.
MfG
Hans

Die ganze fehler, bitte.

Typically a watchdog failure indicates a real time issue with the host computer.

What is the result of:

sudo chrt 99 ping -i .001 -c 60000 -q 10.10.10.10

This should run 1 minute and then print out timing statistics

(replace the 10.10.10.10 with 192.168.1.121 if your 7I96 is jumpered that way))

Ich habe den Befehl eingegeben, es macht aber nur einen Durchlauf. Es kommt diese Meldung:
PING 10.10.10.10 (10.10.10.10) 56(84) bytes of data
--- 10.10.10.10 ping statistics ---
6000 packets transmitted, 6000 received, 0% packet loss, time 6010ms
rtt min/arg/max/mdev = 0.059/0.069/0.174/0.004ms

That looks OK, but I  would go longer, that's why I suggested 60000 (= 1 minute)

Hallo, da habe ich eine Null vergessen.

PING 10.10.10.10 (10.10.10.10) 56(84) bytes of data
--- 10.10.10.10 ping statistics ---
60000 packets transmitted, 60000 received, 0% packet loss, time 60110ms
rtt min/arg/max/mdev = 0.055/0.071/0.181/0.004ms

OK that sounds.

Not sure why you are getting the watchdog bite

What is the host computer, and have all power saving option been disabled in the BIOS?