XY/UV axis config

Hi Guys,
I have added to my .ini file

[Display]
Geometry = XY;UV
FOAM = 1

What this does is showed me the Axis GUI in the form of XY & UV.

however, the issue being that the representation insist that the Z-axis is still there...
not sure why, the XY is lying flat on the floor, with Z in the middle as the normal Z axis, and above the Z-axis is the UV axis.

is there any way, I can perhaps tilt this GUI somewhere in my .ini file or axis file for this to show up correctly?

X & U = horizontal axis
Y & V = vertical axis

thanks in advance

If you look at the foam sample config
git.linuxcnc.org/gitweb?p=linuxcnc.git;a...6e14b28883fe;hb=HEAD

It also has
Try that.

not at this moment , it would need changes to Axis Gui ,

cncbasher wrote: not at this moment , it would need changes to Axis Gui ,

The Foam display did include changes to the Axis GUI, wasn't removing Z one of them?

I will try that when I get back to the office.

thanks for the help!