Glade File and Handler file Location

More
6 years 11 months ago #151282 by mmt
Glade File and Handler file Location was created by mmt
I am running Debian 7 Wheezy and linuxcnc 2.7.14

Where is the glade file and handler for Gscreen Lathe located at?

Thanks
Kent

Please Log in to join the conversation.

More
6 years 11 months ago #151296 by cmorley
Replied by cmorley on topic Glade File and Handler file Location
in a RIP system:
/share/linuxcnc/gscreen.glade
It doesn't use a handler file for that screen.

Other screens are found here (RIP)
share/gscreen/skins/

If yours is an installed version I would need to look that up.. probably /usr/share/linuxcnc/

Chris

Please Log in to join the conversation.

More
6 years 11 months ago #151297 by mmt
Replied by mmt on topic Glade File and Handler file Location
Thank you

Please Log in to join the conversation.

Time to create page: 0.212 seconds
Powered by Kunena Forum