How can I get GladeVCP?

I would like change Gmoccapy. So I need GladeVCP.

In manual is written:
linuxcnc.org/docs/2.8/html/gui/gladevcp....adevcp:prerequisites

but dont work.

Could you help me, please?

Up ! Same for me

Same for me

This isn't a good answer, but it is the simplest solution for me. I have one of the older Wheezy based Linuxcnc ISO installed in a VM on the PC I develop my configs on. It has the right version of Glade installed by default. I set up the UI files there then copy them over to the machine where I want to use them.

There may be a solution for installing the GTK2 version of Glade on Buster, but I don't know it.

There is a package called imply "glade" though that might only work with gtk3.

On the Pi there is a package called "glade-3" which is glade-gtk2, though that might not help.

LinuxCNC did back-port glade-gtk2 on Wheezy, so you could try the deb package here: www.linuxcnc.org/dists/wheezy/base/binary-amd64/ though it might refuse to run on Buster.

you will need to compile glade 3.8.6 from source code.

In this post I described how to install Mint 19 with glade 3.8.6, the part of installing glade should fit your needs. Please uninstall all glade using synaptic prior to installing glade 3.8.6

Norbert

newbynobi wrote: you will need to compile glade 3.8.6 from source code.

Not any more

For Buster / amd64 I have put a package "glade-gtk2" on the LinuxCNC repository.
And there is a pre-existing package for Raspbian.

For Buster with the LinuxCNC 64-bit kernel: For Raspbian on Pi

I cannot install glade2 on Buster:
E: Unable to locate package glade-gtk2

This is in my sources.list:

probotix wrote: I cannot install glade2 on Buster:
E: Unable to locate package glade-gtk2

sudo apt-get update and try again?

Ok it worked for me after the 'update'
Thanks