An error occurred when opening racktoolchange

More
2 years 11 months ago #284606 by onceloved
An error occurred when opening racktoolchange was created by onceloved
An error occurred when opening racktoolchange. The report file is in the attachment. How to solve it? 

Attachment not found

 

 

Attachment not found

 

Attachment not found

Please Log in to join the conversation.

More
2 years 11 months ago #286013 by andypugh
Replied by andypugh on topic An error occurred when opening racktoolchange
I suspect that this is a Gtk2 to Gtk3 transition problem.
Are you running the racktoolchange.ui from LinuxCNC 2.9.1 or a version from an older release (Note that I have no idea if anything has changed)

Can you check if you get the same problem running the rack toolchange sim config from the LinuxCNC install?

Please Log in to join the conversation.

Time to create page: 0.080 seconds
Powered by Kunena Forum