CW/CCW output

More
10 years 1 month ago #79912 by Vladimir
CW/CCW output was created by Vladimir
Hi there!

Can LinuxCNC-gurus tell me how to configure LinuxCNC to output cw/ccw signals instead os step/dir?

Please Log in to join the conversation.

More
10 years 1 month ago #79914 by andypugh
Replied by andypugh on topic CW/CCW output
linuxcnc.org/docs/2.7/html/hal/rtcomps.html

set step_type to 1

Please Log in to join the conversation.

More
10 years 1 month ago #79915 by Vladimir
Replied by Vladimir on topic CW/CCW output
Thank for your reply!
Tell me please should i edit files manually after stepconf finish?

Please Log in to join the conversation.

More
10 years 1 month ago #79921 by andypugh
Replied by andypugh on topic CW/CCW output
Yes.

View Stepconf as something that creates a basic config for you, but the config is the Hal and ini files which are designed for hand editing and to be human-readable.

Please Log in to join the conversation.

More
10 years 1 month ago #79924 by Vladimir
Replied by Vladimir on topic CW/CCW output
Ok. TY! I'll try it tomorrow.

Please Log in to join the conversation.

Time to create page: 0.086 seconds
Powered by Kunena Forum