Why does external switch not work?

Hallo Norbert,
vielen Dank für deine Hilfe. So hat es funktioniert. Ob ich jemals begreife warum der Startbefehl funktioniert hat aber der Stopbefehl nicht,
das weiß ich nicht.
Dazu noch eine kleine Frage: Kann man es irgendwie machen das die Spindel nach dem Stopbefehl an eine bestimmte Position fährt?

MfG

Hans

Hello Norbert,
i am thinking wrong, when there is horizontal driller or a saw in the spindle there is a crush, when moving automaticly to a parkposition
when i push the stop switch, but is it possible an extra switch with i can move the spindle to a park position.

Thanks

Hans
Habs in englisch probiert, da verstehen es vielleicht noch ein paar mehr.

Holzwurm56 wrote: Hello Norbert,
i am thinking wrong, when there is horizontal driller or a saw in the spindle there is a crush, when moving automaticly to a parkposition
when i push the stop switch, but is it possible an extra switch with i can move the spindle to a park position.

Thanks

Hans
Habs in englisch probiert, da verstehen es vielleicht noch ein paar mehr.

I am not 100% sure what your asking but i will take a stab at it.
You can use a physical button to move the xyz to where ever you want with mdi commands in your hal. Is that what your trying to do
And what machine is this on? By the sounds of it, it is a point to point router.......

Bob

Hello Bevins,
it's a maching center for wood, with vertikal and horizontal milling and drilling spindles. You are right, i looking for a physikal switch to move the axis to a definied xyz position.

Thanks

Hans

Create a MDI command to move to the location you want and connect it to your switch in hal.

linuxcnc.org/docs/2.7/html/config/ini-co...ml#sec:halui-section

First add the MDI command then run your config and look at the show hal to see the pin name then connect it up in hal to your switch.

JT

Holzwurm56 wrote: Hello Bevins,
it's a maching center for wood, with vertikal and horizontal milling and drilling spindles. You are right, i looking for a physikal switch to move the axis to a definied xyz position.

Thanks

Hans

Is it a Biesse by chance?

Hello Bevins,
it's a BIMA600U, Manufacturer IMA.

Thanks

Hans

Holzwurm56 wrote: Hello Bevins,
it's a BIMA600U, Manufacturer IMA.

Thanks

Hans

WOW, Nice. Now thats some serious mortise horizontal milling.
I have the capabilities similar but not that robust of horizontal milling.

Good luck. How far have you got with the retrofit?


Bob

Hello Bevins,
the machine works in a basic job. The axis are moving, homing and running a g-code program. I have buy a new(used) drilling head with spindle distance from 32mm. The originial had 50mm. When the mechanical work of the machine is complete, i will test to write some subroutines for my furnituremaker job. I do not now of i am able to do this sucsessful, but i hope with help i can do it.

Thanks

Hans

Holzwurm56 wrote: Hello Bevins,
the machine works in a basic job. The axis are moving, homing and running a g-code program. I have buy a new(used) drilling head with spindle distance from 32mm. The originial had 50mm. When the mechanical work of the machine is complete, i will test to write some subroutines for my furnituremaker job. I do not now of i am able to do this sucsessful, but i hope with help i can do it.

Thanks

Hans

Did you get your stop button working?