Config Yaskawa Servo SGDH-30DE-0Y step/dir

I HAVE servo SGDH-30DE-0Y(driver SGMGH-30DCA6F-0Y With 17 bit encoder utsih-b17ck )
Screw pitch 10mm Z axis, 5mm X Axis
I have a few questions at the bottom:
SGDH-30DE-0Y
Pn000 Control mode selection = n0010.
Pn202 Electronic Gear Ratio (Numerator)?
Pn203 Electronic Gear Ratio (Denominator)?
Linuxcnc
Motor steps per revolution=32768X4?((
Driver microstepping =1?

The final answer is a single "SCALE" number in the INI. It doesn't matter how you get to that number as long as it is the right number. You could just calulate it by hand, it needs to be steps/inch or steps/mm depending on machine units.