xhc-hb04 error

hello
after settling an existing and working configuration and adding the necessary I found this error:
CANNOT FIND FILE FOR: monitor_xhc-hb04.tcl
I attach if it was to serve the beginning of the messages
regards
Mauro


edit: simulator work properly

It looks like these lines hold the key.

So what it looks like to me is that the file
/usr/share/linuxcnc/hallib/xhc-hb04.tcl

is looking for:
monitor_xhc-hb04.tcl

edit /usr/share/linuxcnc/hallib/xhc-hb04.tcl to see if you get any clues where the missing file should be.
So if you can find that file, you can either put it where its expected to be or edit the filename and path in the first file so it can find it.

Sorry, but I've never used your hardware. This is just basic troubleshooting.

thanks Rod
but it just does not seem to have that file ...
I will control better

The reported name monitor-xhc-hbo4.tcl is incorrect
(there is no .tcl in the correct name.)
and the item appears in the [APPLICATIONS] section
not the [HAL] section

From the README in the sim config directory:

Ref:
github.com/LinuxCNC/linuxcnc/blob/2.7/co...axis/xhc-hb04/README

(It is easier to help if you post relevant config files especially your ini file)

Thank you!
it was already well in [APP], but it was also repeated in the [HAL] section
it was enough to delete that.


I had seen here: wiki.linuxcnc.org/cgi-bin/wiki.pl?Using_...Wireless_MPG_Pendant

[HAL]
<existing entries here>
HALFILE=xhc-hb04.tcl
HALFILE=monitor_xhc-hb04.tcl
HALUI = halui

That portion of the wiki entry is clearly wrong.

No one takes responsibility for reviewing or maintaining wiki entries.

However, numerous contributors attempt to update and maintain
documentation within the LinuxCNC project.