Mesa 5i25+7i76 position-fb running

More
8 years 9 months ago #104271 by grijalvap
Mesa 5i25+7i76 position-fb running was created by grijalvap
Hi
I have a configuration with mesa 5i25+one 7i76 running on 2.8 master, it was working fine until yesterday when I turn on the equipment, all the axis are getting feedback. even if the machine e-stop is off and the input command is 0,
does anybody have any clue?
Here is a small video of the DRO



thanks..

Please Log in to join the conversation.

More
8 years 9 months ago #104288 by PCW
Replied by PCW on topic Mesa 5i25+7i76 position-fb running
That's really strange. If its not something really odd in hal
its looks like a PCI/5I25 connection issue (card partially out of slot/ dirty contacts/etc)

Please Log in to join the conversation.

More
8 years 9 months ago #104314 by grijalvap
Replied by grijalvap on topic Mesa 5i25+7i76 position-fb running
Hi
I have double checked the installation and it is ok, then I replaced the 5i25 card with other and it behaves in the same way.
do you recommend install LinuxCNC again?

Thanks.

Please Log in to join the conversation.

More
8 years 9 months ago #104315 by PCW
Replied by PCW on topic Mesa 5i25+7i76 position-fb running
That's really bizarre... can you do:

halcmd show all > all.txt

when its behaving this way
and attach the all.txt file here?

Please Log in to join the conversation.

More
8 years 9 months ago #104317 by grijalvap
Replied by grijalvap on topic Mesa 5i25+7i76 position-fb running
hi
here is the file thanks for your help


Attachment not found

Please Log in to join the conversation.

More
8 years 9 months ago #104320 by PCW
Replied by PCW on topic Mesa 5i25+7i76 position-fb running
Well if the count is changing and the stepgen commanded velocity is 0 , I really have no clue
bug in master? Hardware failure on PC? Really only guessing now

Please Log in to join the conversation.

More
8 years 9 months ago #104321 by grijalvap
Replied by grijalvap on topic Mesa 5i25+7i76 position-fb running
well i think it start after one upgrade.
How we can make this message visible to mesa people.

Please Log in to join the conversation.

More
8 years 9 months ago #104325 by skunkworks
Replied by skunkworks on topic Mesa 5i25+7i76 position-fb running
I think seb was seeing this on the tip of master...

tom-itx.no-ip.biz:81/~tom-itx/irc/logs/%...evel/2018-01-10.html

(on irc)

Please Log in to join the conversation.

  • seb_kuzminsky
  • New Member
  • New Member
More
8 years 9 months ago #104329 by seb_kuzminsky
Replied by seb_kuzminsky on topic Mesa 5i25+7i76 position-fb running
That sounds similar to what I was seeing. Please post the output of this command:

grep 'upgrade linuxcnc' /var/log/dpkg.log

Please Log in to join the conversation.

More
8 years 9 months ago #104330 by grijalvap
Replied by grijalvap on topic Mesa 5i25+7i76 position-fb running
thanks
here is the result file

Please Log in to join the conversation.

Time to create page: 0.091 seconds
Powered by Kunena Forum