Probe error!

Hi all, I managed to install all correctly and my machine it's working fine. However when I try to say from the "stepconf wizard" that I have a probe on the Pin 11 of my board, when I try to open my configuration and jog, I got always this error:
"Probe tripped during a jog"
And in this way I can't jog, I receive this error every time I try to jog.
From the Hal meter I can see that my probe is working correctly, so I can't figure out the reason of this error that I got.

Can you help me?

Thanks a lot

What about MDI?

Can't perform MDI moves too! Every time I try to move something I got the error. The probe is always disconnected of course but it gives me error as soon as I move an axis. If you need more information tell me (I'm sorry I'm new on linux cnc configurations)

sarcokiller wrote: Can't perform MDI moves too! Every time I try to move something I got the error. The probe is always disconnected of course but it gives me error as soon as I move an axis. If you need more information tell me (I'm sorry I'm new on linux cnc configurations)

It would help people if you posted your config files from the config folder ie xxx.ini and xxx.hal

Ok, thank you for the reply!


EDIT:
SOLVED!
I solved the problem setting debounce to Probe-in signal!