clock

More
7 years 7 months ago #128127 by deslee848
clock was created by deslee848
hello guys,at first place i install Lcnc,but didnt care about the clock and date.so in Lcnc where can adjust the clock and date. thanks

Please Log in to join the conversation.

More
7 years 7 months ago #128131 by ant0ny
Replied by ant0ny on topic clock
I had same issue and was surprised it wasn't as straight forward as I thought.

wiki.debian.org/TimeZoneChanges

First I tried this wiki which didn't actually work for my first few installs... I was trying different setups and video cards etc.

After not getting it to work I installed NTP which fixed the issue. You may need to set the "local sources" as per the instructions.

wiki.debian.org/DateTime

Irony was after all that I did a final install but did the text based install instead of the gui install and it worked first go without any extra fix after install.

Please Log in to join the conversation.

More
7 years 7 months ago #128135 by pl7i92
Replied by pl7i92 on topic clock
can be adchived easy in a side panel
by XML
Code:
<hbox> <label> <text>"Cycle Time"</text> <font>("Helvetica",14)</font> </label> <u32> <halpin>"time-hours"</halpin> <font>("Helvetica",14)</font> <format>"2d"</format> </u32> <label> <text>":"</text> <font>("Helvetica",14)</font> </label> <u32> <halpin>"time-minutes"</halpin> <font>("Helvetica",14)</font> <format>"2d"</format> </u32> <label> <text>":"</text> <font>("Helvetica",14)</font> </label> <u32> <halpin>"time-seconds"</halpin> <font>("Helvetica",14)</font> <format>"2d"</format> </u32> </hbox>

and in the postgui HAL
Code:
loadrt time addf time.0 servo-thread ## net prog-running not.1.in <= halui.program.is-idle net cycle-timer time.0.start <= not.1.out net cycle-seconds pyvcp.time-seconds <= time.0.seconds net cycle-minutes pyvcp.time-minutes <= time.0.minutes net cycle-hours pyvcp.time-hours <= time.0.hours

Please Log in to join the conversation.

Time to create page: 0.075 seconds
Powered by Kunena Forum