Tool change position different for ATC and Manuell TC

7 years 7 months ago #129363 by pl7i92

Tool change position different for ATC and Manuell TC was created by pl7i92

Hi is it possible to have for the first 6 tools as in ATC a different toolchange position then for the Tools Nr above 6

Please Log in to join the conversation.

7 years 7 months ago #129420 by andypugh

Replied by andypugh on topic Tool change position different for ATC and Manuell TC

Not using G38 or the built-in retract.

But if you remap the M6 command, then you can do this easily.

Please Log in to join the conversation.

7 years 7 months ago #129446 by pl7i92

Replied by pl7i92 on topic Tool change position different for ATC and Manuell TC

i thik im out of mind as i did remap the M6
not getting this in
THANK you

Please Log in to join the conversation.

Time to create page: 0.075 seconds