Linuxcnc always wants to update my INI file

More
7 years 3 months ago #140512 by Clive S
Replied by Clive S on topic Linuxcnc always wants to update my INI file

JetForMe wrote: So, it sounds like the documentation is incorrect, then.


The docs were probably written before the configuration tools were made

Please Log in to join the conversation.

More
7 years 3 months ago #140525 by Todd Zuercher
Replied by Todd Zuercher on topic Linuxcnc always wants to update my INI file
Yes, the docs are incorrect, and should be updated.

Please Log in to join the conversation.

More
7 years 3 months ago #140561 by JetForMe
Replied by JetForMe on topic Linuxcnc always wants to update my INI file

tommylight wrote: I have not yet done much testing on 2.9, but 2.8 requires that to be 1.1
Anything else and it will try to run the wizard to change the version.


Thanks, Tommy. 1.1 works in 2.9, too. I had 1.1, at some point it complained, but now it's not complaining.

Please Log in to join the conversation.

More
7 years 3 months ago #140564 by tommylight
Replied by tommylight on topic Linuxcnc always wants to update my INI file
You are welcomed.

Please Log in to join the conversation.

More
7 years 3 months ago #140646 by BigJohnT
Replied by BigJohnT on topic Linuxcnc always wants to update my INI file
It's a good practice to use the documents for the branch your using.

linuxcnc.org/docs/2.8/html/config/ini-config.html#_emc_section

JT

Please Log in to join the conversation.

More
7 years 3 months ago #140704 by JetForMe
Replied by JetForMe on topic Linuxcnc always wants to update my INI file
I'm using 2.9, and those docs say "It’s a good idea to change this number each time you revise your file."

Please Log in to join the conversation.

More
7 years 3 months ago #140743 by BigJohnT
Replied by BigJohnT on topic Linuxcnc always wants to update my INI file
The 2.8 and 2.9 docs say:
Code:
VERSION = 1.1 - The version number for the configuration. Any value other than 1.1 will cause the configuration checker to run and try to update the configuration to the new style joint axes type of configuration.

You might need to refresh your browser with Ctrl Shift r

JT

Please Log in to join the conversation.

More
6 years 9 months ago #154141 by DC67
Replied by DC67 on topic Linuxcnc always wants to update my INI file
hello
i changed my ini file because i want to use probe screen v2 with gmoccappy. now i always get a message at linuxcnc start (picture) i have been using v2.8 for a while without any problems and the update that he suggests doesn't work. if I click no then everything goes on normally. what am I doing wrong here?

Attachment not found


Attachment not found

Please Log in to join the conversation.

More
6 years 9 months ago #154161 by Mike_Eitel
Replied by Mike_Eitel on topic Linuxcnc always wants to update my INI file
I think Version 1.1 must be adapted. A while agoo there was something about it here on the forum

Please Log in to join the conversation.

More
6 years 9 months ago #154369 by andypugh
Replied by andypugh on topic Linuxcnc always wants to update my INI file
Is this fixed?

Please Log in to join the conversation.

Time to create page: 0.062 seconds
Powered by Kunena Forum