I'm upgrading my system from 2.5 to master.
It is a dual gantry system (2 motors on Y, 2 on Z).
I've gone through the process of renaming .ini entries and hal pins. I haven't changed any values.
Axis starts up, but there is no "Home all" button any more. I am in joint mode, and only get the option to "home joint" and pick an individual joint - although nothing happens when I click the button.
Attachment not found
The old system would home both Z joints, then the Y pair and X together. I'm using limit switches on each axis, then the index on the servo encoder, then move off to square the gantry.
I haven't changed any homing configuration - I see there is now support for specifying a negative HOME_SEQUENCE but I don't see a need to use it.
Are there new flags or pins I need to set?
ini and hal attached.
Attachment not found
Attachment not found
