Hi everyone,
I am trying to interface a mesa 7i80db (the motherboard) with a 7i76 (the daughtercard). The 7i80db communicates with linuxCNC through ethernet connection. Currently, I'm trying to see if the communication works correctly, however LinuxCNC seems to recognize only the 7i80db but not the 7i76. The steps I've tried are:
Code:
halrun
halcmd: loadrt hostmot2
halcmd: loadrt hm2_eth board_ip=192.168.1.121
hm2_eth: loading Mesa AnyIO HostMot2 ethernet driver version 0.2
hm2_eth: 192.168.1.121: Hardware address: 00:60:1b:10:00:5d
hm2_eth: discovered 7I80DB-16
hm2/hm2_7i80.0: Smart Serial Firmware Version 43
hm2/hm2_7i80.0: 68 I/O Pins used:
hm2/hm2_7i80.0: IO Pin 000 (J2-01): StepGen #0, pin Direction (Output)
hm2/hm2_7i80.0: IO Pin 001 (J2-14): StepGen #0, pin Step (Output)
...
hm2/hm2_7i80.0: IO Pin 067 (J5-13): IOPort
hm2/hm2_7i80.0: registered
sysctl: cannot stat /proc/sys/net/ipv6/conf/eth0:avahi/disable_ipv6: No such file or directory
hm2_eth: ERROR: Failed to execute '/sbin/sysctl -q net.ipv6.conf.eth0:avahi.disable_ipv6=1'
Do you have any idea on what might be the problem. Thank you in advance.
