G-Code Newbie Question

I have a file created in Fusion 360. I believe my program is stopping on the T1 M6 command, manual tool change? But I'm not getting a message dialog to indicate tool change.

I did not consciously setup for manual tool change. Is there some HAL or INI configuration you have to edit to have manual tool change?

yes you must configure a manual tool change prompt.
usually by loading and connecting to the hal_manualtoolchange component.

Not knowing more about your machine configuration, my guess is that it is actually pausing for the line "N25 T1 M6" which is commanding a tool change to tool #1. If you don't have a tool changer and your config isn't properly configured for not having one, or if you do have a tool changer and your configuration is somehow wrong regarding it, that is what happens. Without seeing your config files or knowing more about your machine, we are only guessing.

@Project_Hopeless
No double posting
The other topic with the same content was deleted, Todd's answer moved to this topic.

For manualtoolchange sometimes this solves in hal.

MaHa wrote: For manualtoolchange sometimes this solves in hal.

Code:

loadusr -W hal_manualtoolchange net tool-change iocontrol.0.tool-change => hal_manualtoolchange.change net tool-changed iocontrol.0.tool-changed <= hal_manualtoolchange.changed net tool-number iocontrol.0.tool-prep-number => hal_manualtoolchange.number net tool-prepare-loopback iocontrol.0.tool-prepare => iocontrol.0.tool-prepared

Thank-you I will give it a try.

Does it matter where in the HAL file these code lines are placed? This is copied to the main HAL file or postGUI.hal, or other?

Always at the bottom of the main hal file.

Thank-you all! That worked like a charm.