mux 4 not recognized

hello, I am new to the forum, but not to linuxcnc, I have been trying to scramble on it for a few months.
(see my video you tube)
at the moment, i can't connect the "mux4" component, it is not recognized, do you have any idea, sorry for the spelling, i'm french

configuration: 2 cards // db 25 + 1 Chinese bob for this example

with the modified "mpg .hal" I can move the pap, but not change the speed

but inside, there is not the "mux4"

The error in on line 6 of custom.hal...

jpg wrote: hello, I am new to the forum, but not to linuxcnc, I have been trying to scramble on it for a few months.
(see my video you tube)

at the moment, i can't connect the "mux4" component, it is not recognized, do you have any idea, sorry for the spelling, i'm french

configuration: 2 cards // db 25 + 1 Chinese bob for this example

Attachment not found

with the modified "mpg .hal" I can move the pap, but not change the speed

Attachment not found

Attachment not found

but inside, there is not the "mux4"

Can you post the complete config ,you have not posted the custom.hal

Also have you edited anything in a word processor as that is a no no, always use a text editor like notepad etc.

Clive S wrote:

jpg wrote: hello, I am new to the forum, but not to linuxcnc, I have been trying to scramble on it for a few months.

at the moment, i can't connect the "mux4" component, it is not recognized, do you have any idea, sorry for the spelling, i'm french

configuration: 2 cards // db 25 + 1 Chinese bob for this example

Attachment not found

with the modified "mpg .hal" I can move the pap, but not change the speed

Attachment not found

Attachment not found

but inside, there is not the "mux4"

Can you post the complete config ,you have not posted the custom.hal

Also have you edited anything in a word processor as that is a no no, always use a text editor like notepad etc.

sorry I had erased the custum .hal, I put all my configuration, what I do not understand is that it does not recognize this component (
and I only open the files with the notepad)"mux4" so useful for an MPG, mine will be in 2 axis for lathe

there can be no spaces between count =
loadrt and2 count=3
loadrt mux4 count=2

And if you have to edit Linux files on a windows PC, use Notepad only.
The error says there are windows line endings in the file.

cmorley wrote: there can be no spaces between count =
loadrt and2 count=3
loadrt mux4 count=2

good evening, a big thank you, that was it, I still have to find the entries for the mpg, I have the signals in the halscope

On windows it is the best to use notepad++ as editor.
And additionally winscp plus even xrdp (on linux side)
That gives you an easy remote accessed working platform.
You could even run a job, what i personally would never do.
Mike